The VK_PACKET key is the low word of a 32-bit Virtual Key value used for non-keyboard input methods. Used to pass Unicode characters as if they were keystrokes. The keys on the US standard keyboard, or the \\| key on the non-US 102-key keyboard Used for miscellaneous characters it can vary by keyboard. For the US standard keyboard, the 'single-quote/double-quote' key For the US standard keyboard, the '[' key For the US standard keyboard, the '`~' key For the US standard keyboard, the '/?' key For the US standard keyboard, the ' :' key IME Hanguel mode (maintained for compatibility use VK_HANGUL) 8.The following table shows the symbolic constant names, hexadecimal values, and mouse or keyboard equivalents for the virtual-key codes used by the system. Having the 4 oaitun_ue tunnel interfaces up and with an allocated address means the connection with EPC went alright. You can change those numbers above to whatever key combination you like by referring to a keyboard key code list like this. This is difficult for the user and relies often on entering hex codes for WPA keys at. ci-scripts/conf_files/ue.nf -noS1 -L2-emul 3 -num-ues 64 -nums_ue_thread 1 -nokrnmod 1 > ue.log 2> & 1Įns3 Link encap:Ethernet HWaddr XX:XX:XX:XX:XX:XX How many UE that can be tested depends on hardware (server, PC, etc) performance in your environment. The -nokrnmod 1 option makes use of the preferred and supported tunnel interface. This number SHALL NOT be greater than the number of UEs.Īt the time of writing, it seems to be enough to run on a single thread. The number of threads can set with the -nums-ue-thread. The number of UEs can set by using -num-ues option and the maximum UE number is 255 (with the -mu* options, otherwise 16). ci-scripts/conf_files/ue.nf -noS1 -L2-emul 3 -num-ues 64 -nums_ue_thread 1 -nokrnmod 1 -T 1 > ue.log 2> & 1 # The "-T 1" option means TDD config ci-scripts/conf_files/ue.nf -noS1 -L2-emul 3 -num-ues 64 -nums_ue_thread 1 -nokrnmod 1 > ue.log 2> & 1 # Test 64 UEs, 1 thread in TDD mode Please try to use the same commit ID on both eNB/UE hosts. But you may face issues that could be fixed in newer develop tags. The tutorial should be valid for the master branch tags such as v1.2.0 or v1.2.1. Retrieve the OAI eNB-UE source code Īt the time of writing, the tag used in the develop branch to do this documentation was 2020.w16. Note that the IP addresses are indicative and need to be adapted to your environment. Machine C contains the OAI UE(s) executable ( lte-uesoftmodem)Įxample of L2 nFAPI Simulator testing environment: Machine B contains the OAI eNB executable ( lte-softmodem) You can use Virtual Machines instead of each server like it is done in the CI process. You may not have access to an EPC or you don’t want to hassle to deploy one.Ģ servers are used in this deployment. Setup of the USIM information in UE folder L2 nFAPI Simulator (no S1 Mode / 2-host deployment)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |